Deep cleaning, re-sanding and sealing of brick and concrete pavers. Locks joint sand, stops weed growth and brings the color back.
We install paver sealing throughout Tampa, St. Petersburg, Sarasota and Lakeland, plus Clearwater, Brandon, Riverview, Bradenton, Venice, Plant City and Winter Haven.
Pressure wash the stones and the joints, then treat oil, rust and mildew separately — those do not come up with water alone. Everything dries fully before anything else happens. Sealing dirty or damp pavers locks the problem in permanently and the only fix after that is stripping.
Fresh sand worked down into every joint and compacted. This is the structural step, not a cosmetic one — loose joints are why pavers shift and rock underfoot, why sand keeps washing out in heavy rain, and where weeds and ant hills get established in the first place.
A two-component polyurethane goes over the top. It cures into a hard film rather than soaking in and wearing off the way cheap single-part sealers do, which is where the long service life comes from.
A sealed surface that separates the stone from the outside elements. Nothing grows in the joints, dirt sits on top instead of soaking into the pavers, and the colour holds instead of bleaching out. Rinse it off and it looks the way it did the day we left.
High gloss with deeply saturated colour, like the pavers are permanently just-rained-on. The most requested finish and the biggest visual change from where you are starting.
Between wet look and matte. Enriches the colour without the full shine. A good middle ground for large driveways where full gloss can be a lot.
Protection with almost no change in appearance. For people who like their pavers as they are and want them defended from staining and weeds.
Restores faded pavers that have been sun-bleached for years. Brings the original tone back rather than adding a new one.
Polymeric sand worked into every joint and locked in place by the sealer. This is the part that stops weeds, ants and sand washout, and it is the part cheap jobs skip.
Paver sealing is priced per square foot and the range is wide, because most of the work is prep, not sealer. Anyone quoting cheap is skipping the cleaning, the stain treatment or the re-sanding — and all three determine whether the result lasts.
Price moves on square footage, how dirty the pavers are (mildew, oil, rust and irrigation staining all take extra treatment), how much joint sand has washed out, and finish choice.
Sealing dirty pavers locks the dirt in permanently. It is the single most common way this job gets done wrong, and it cannot be undone without stripping.
Get a Firm Written Quote →A properly cleaned, re-sanded and sealed paver surface holds for two to four years in Florida. Driveways in full sun sit at the short end, shaded walkways and covered lanais at the long end.
Re-sealing is far easier than the first job — the deep clean and full re-sand are already done, so maintenance rounds cost less and go faster.
You will know it is due when water stops beading and the colour starts flattening out. Sealing before it fully wears is cheaper than waiting until the joints are gone.
Every paver sealing job we do starts the same way regardless of which city it is in — an on-site look at the actual slab, moisture testing where it is warranted, and a firm written price before anything starts.
In Tampa and Hillsborough County we work everything from 1920s bungalow slabs in South Tampa to new-build garages in Westchase and New Tampa. Across the bay in St. Petersburg and Pinellas County, salt air off the Gulf and the bay changes what holds up, so exterior specs there always account for it. Down in Sarasota and Manatee County — Siesta Key, Lakewood Ranch, Palmer Ranch, Venice — decorative and premium finishes make up most of the work. And in Lakeland and Polk County, larger lots, detached garages and workshop slabs are where high-build systems earn their keep.
Free estimates in all four, no travel charge. Request a quote or call (813) 603-7455.
Resin floor systems that bond into the slab and cure hard. A polyaspartic topcoat adds UV stability and gets you back on the floor in a day.
Learn more →Sprayed and troweled texture that gives concrete a slip-resistant profile. The standard for Florida pool decks because it stays cool and grips wet.
Learn more →Acid and water-based stains that soak into the slab and react with it. The color lives inside the concrete instead of sitting on top, so it cannot peel or chip off.
Learn more →A cementitious layer troweled over existing concrete. Fixes spalling, discoloration and surface damage without tearing the slab out.
Learn more →Every two to four years depending on sun exposure and traffic. Driveways in full sun are on the shorter end.
Largely, yes. Weeds come from joint sand washing out. We re-sand with polymeric joint sand and seal it in, which locks the joints and removes the place weeds and ants get established.
Wet-look for deep saturated color and gloss, matte for a natural look with protection, or natural finish that barely changes appearance. Wet-look is the most requested.
Always. Sealing dirty pavers locks the dirt in permanently. Every job includes pressure washing, stain treatment and full drying time before any sealer goes down.
Free on-site estimate, firm written pricing, no pressure. Most residential jobs finish in one to two days.